P2667 Audi OBD2 specifically refers to the camshaft (cam) timing. In this case, if the cam timing is over-retarded, the engine light will be illluminated and the code will be set.
The problem is caused by the variable cylinder management system switching on and off during light throttle conditions, at cruising speeds, or when driving on flat roads. The constant switching causes excessive oil consumption and the trouble codes appear when oil pressure drops to the point where it can no longer operate the VCM system.
The crankshaft sensor signals the fuel injection computer or the ignition control when the cylinders are firing. This causes the ignition coil to provide a spark and the injector to inject fuel into each cylinder at the right time.If either sensor isn't working correctly, the car will run rough and the engine will be less efficient. In later car models, the car's computer can usually keep the vehicle running, but the engine warning light on the dashboard goes on to warn the driver.
P2667 meaning and repair processes are the same for all Audi models.
P2667 Audi Trouble Repair Process:
The sensors receive a 5 volt reference signal from the PCM. As pressure readings change, the sensor varies the voltage and the computer reads that to determine input. In the case of a broken wire, the sensor never sees the voltage and the computer assumes a major fault. So if you get this P2667 Audi code, first check to make sure you're getting a good 5 volt reference signal at the sensor.
It works by having a slightly higher than normal opening temperature, which still works the same way as regular ones, but it also has a heating coil, which means the ECU can open the thermostat earlier and keep the engine slightly cooler.